Good morning all,
I think I might be spending some time here on MCAD in your Inventor world for awhile. I have been using Pro/E for the better part of 15 years and Solidworks on and off throughout those years. I have just taken a job where all they use here is Inventor version 2009.
I have been able to somewhat get everything done I need to some extent. I do have a question if I may. Is there a way to section a part in the model then save that as a view? For design purposes as well as bring that view in later to the drawing? I am sure you can section in the drawing but I want to be able to do this in the model as well. Lastly, how do I turn on my coordinate system and datum planes so they appear upon new part start up? We in our Pro/E world had a config file where we could taylor make the software to our personal preference. One more lastly sorry, is there a way to put the orbit rotate tool on my mouse or right click?
Thanks all.
Sid
I think I might be spending some time here on MCAD in your Inventor world for awhile. I have been using Pro/E for the better part of 15 years and Solidworks on and off throughout those years. I have just taken a job where all they use here is Inventor version 2009.
I have been able to somewhat get everything done I need to some extent. I do have a question if I may. Is there a way to section a part in the model then save that as a view? For design purposes as well as bring that view in later to the drawing? I am sure you can section in the drawing but I want to be able to do this in the model as well. Lastly, how do I turn on my coordinate system and datum planes so they appear upon new part start up? We in our Pro/E world had a config file where we could taylor make the software to our personal preference. One more lastly sorry, is there a way to put the orbit rotate tool on my mouse or right click?
Thanks all.
Sid