erogers7053
New member
I have two lines in 3D sketch mode.
The direction of one is fixed, and the two endpoints are fixed in space. I wish there was a way to tell the Solidworks to figure out the minimum lengths required to connect both lines.
Does this exist? Is therean equation I can enter?The only thing I can think of is the Quadratic Equation, but that doesnt help me 3-Dimensionally, nor does it help me figure out minimum length......
The direction of one is fixed, and the two endpoints are fixed in space. I wish there was a way to tell the Solidworks to figure out the minimum lengths required to connect both lines.
Does this exist? Is therean equation I can enter?The only thing I can think of is the Quadratic Equation, but that doesnt help me 3-Dimensionally, nor does it help me figure out minimum length......