Results 1 to 2 of 2
  1. #1

    Creo sheetmetal save as problem

    Hi,

    I am facing problem in CREO... saving a sheetmetal part's drawing.

    When a part model is saved in another location , software saves with its associated drawing but when I save a sheet metal part the software is not saving the associated drawing. Is there any variable to control this.

    Thanks
    Regards - Prabhu

  2. #2
    I do not think there is a way, as the drawing is dependent on the model. Just think what about the asm where the part is assembled-- it is not saved either.
    Mike

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •