MachineMike
New member
Hello all,
I am working on a project that requires a lot of copying and reusing of large assemblies. When I do a Save As there are always some parts within the assembly that require them to be copied to a new name. That is fine because I am going to change them anyway, but when it copies parts to a new name it will not copy the drawings even though the Copy Drawings box is checked. This is making my life difficult and it is very time consuming. I am using Creo2 with Windchill. I cannot copy in Windchill since nothing is checked in, and I cannot check in due to some internal issues that need to be fixed (it is a long story). Does anybody have any tips?
Thanks, Mike
I am working on a project that requires a lot of copying and reusing of large assemblies. When I do a Save As there are always some parts within the assembly that require them to be copied to a new name. That is fine because I am going to change them anyway, but when it copies parts to a new name it will not copy the drawings even though the Copy Drawings box is checked. This is making my life difficult and it is very time consuming. I am using Creo2 with Windchill. I cannot copy in Windchill since nothing is checked in, and I cannot check in due to some internal issues that need to be fixed (it is a long story). Does anybody have any tips?
Thanks, Mike