Results 1 to 4 of 4
  1. #1

    Thru hole without the THRU annotation

    Is there a way for CREO to not display the word THRU in the callout when I have a thru hole?

  2. #2
    You will need to create a custom note since, by default the hole notes call up the depth of the hole & the thread if using the hole tables - however if you don't use the hole table, you don't get a hole note unless you specifically create a setup note attached to the hole.

  3. #3
    Hello Robert,
    I found from the ptcusercommunity that I can customize the hole table more than I thought possible.

  4. #4
    I never use the notes that Creo provides.
    They are too long and contain unesecessary information.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts