Hello,
Im new to the forum and looking for a little help.
I have created a part with a set of holes in it. The holes were done using a pattern.
I know need to go back and change the the hole so it is counter sunk. when i go back into edit my initial hole i do not have the options to make changes to the hole. all of the buttons are grayed out.
Do i need to wipe out the pattern and start over?
thanks for the help. Looking forward to being part of the MCAD community.
Daniel
Im new to the forum and looking for a little help.
I have created a part with a set of holes in it. The holes were done using a pattern.
I know need to go back and change the the hole so it is counter sunk. when i go back into edit my initial hole i do not have the options to make changes to the hole. all of the buttons are grayed out.
Do i need to wipe out the pattern and start over?
thanks for the help. Looking forward to being part of the MCAD community.
Daniel