Simon Gulløv Møllenberg
New member
Hi
Really hope you can help, as no one at my work has ever encountered this issue.
I a creating a assembly, with 5 parts, each generated with family table, consisting of 18 parts each. so 5x18 parts
i have created an assembly of the generic models, and have later decided that i need to edit some tapholes placement on the base model of the assembly (the one the others are mated around, not that i think that matters).
What happens is: I can adjust my sketch for pattern, and therefore move the cut holes as i please, veryfying and saving the model with the new placement, is not a problem, i can even regenerate the model in assembly, still no complaints from Creo.. The problem is that when i save, and close it all, and upon reopening the file, everything is back to "normal", like its a read only file, with temporary modification. I have tried making a simple cut or extrude without pattern, but the same story, i can make the feature, verify on family table regenerate in assembly and save and exit with problems, or error messages, but when i open again, back to "normal". i have moved these holes and patterns on 2 others parts in the assembly, since they needed to match, and nothing here, just a simple verify and everything worked as it was supposed to.
The best regards
Simon
Really hope you can help, as no one at my work has ever encountered this issue.
I a creating a assembly, with 5 parts, each generated with family table, consisting of 18 parts each. so 5x18 parts
i have created an assembly of the generic models, and have later decided that i need to edit some tapholes placement on the base model of the assembly (the one the others are mated around, not that i think that matters).
What happens is: I can adjust my sketch for pattern, and therefore move the cut holes as i please, veryfying and saving the model with the new placement, is not a problem, i can even regenerate the model in assembly, still no complaints from Creo.. The problem is that when i save, and close it all, and upon reopening the file, everything is back to "normal", like its a read only file, with temporary modification. I have tried making a simple cut or extrude without pattern, but the same story, i can make the feature, verify on family table regenerate in assembly and save and exit with problems, or error messages, but when i open again, back to "normal". i have moved these holes and patterns on 2 others parts in the assembly, since they needed to match, and nothing here, just a simple verify and everything worked as it was supposed to.
The best regards
Simon