Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

moving spline points when symmetrical about center line

mitip

New member
I Am just getting into depths of Creo 3 after WF5 wher I would routinely make two spline points symmetrical about a cntre line and then be able to move one point and the other followed.
I cant do this in Creo 3. Is it an options setting I have wrong, a change in the interface so I am not going about it properly or is now not possible?
 
You may want to check how your default constraints were set in WF5 against what they are set at now.
 

Sponsor

Articles From 3DCAD World

Back
Top