I am having trouble with the lines on a PDF after they are exported from a drawing to PDF. When exporting all lines seem to be of an appropriate size with the exception of the entity lines. They are so large that you cannot see the detail of the part itself. I have browsed through some similar topics that have come up here throughout the years and have found to do a couple things but it didnt fix my problem. I am using Creo 2.0 and here is what I have set in the configuration options of the drawing:
pdf_use_pentable yes
use_8_plotter_pens yes
pen1_line_weight 1
pen2_line_weight 1
pen3_line_weight 1
pen4_line_weight 1
pen5_line_weight 1
pen6_line_weight 1
pen7_line_weight 1
pen8_line_weight 1
Doing these tweaks has no impact on the exported pdf, if anyone has some suggestions that would be much appreciated.
pdf_use_pentable yes
use_8_plotter_pens yes
pen1_line_weight 1
pen2_line_weight 1
pen3_line_weight 1
pen4_line_weight 1
pen5_line_weight 1
pen6_line_weight 1
pen7_line_weight 1
pen8_line_weight 1
Doing these tweaks has no impact on the exported pdf, if anyone has some suggestions that would be much appreciated.