michaelpaul
New member
If I want to display dimensions on my drawing as dual (US and Metric), why can't I just click a toggle on the toolbar somewhere to activate this option, or why can't I edit the properties of the dimension directly and click a check box that enables this for the selected dimension rather than have to turn on this option using the drawing setup file?
For one, I do this so infrequently that I always have to Google how to do it. because who would think that the way to access the drawing setup file is via File - prepare anyway? Because that sounds obvious? (then again, it's no less obvious than performing a checkout on a file from Creo by clicking File - check in to open the sub-menu that contains the actual check out command but that's a whole other rant......) For another, it just makes no sense. I can change any other thing about the dimension including turning on tolerancing and such but I can't change to dual dimension form the dimension properties? sheesh!
For one, I do this so infrequently that I always have to Google how to do it. because who would think that the way to access the drawing setup file is via File - prepare anyway? Because that sounds obvious? (then again, it's no less obvious than performing a checkout on a file from Creo by clicking File - check in to open the sub-menu that contains the actual check out command but that's a whole other rant......) For another, it just makes no sense. I can change any other thing about the dimension including turning on tolerancing and such but I can't change to dual dimension form the dimension properties? sheesh!