New_User_Help
New member
Hi guys,
I am new to this forum and this is my first post. I just got a new job in Houston and the job requires me to use Creo Schematics 2.0 and Creo Parametric to route 3d harness, then flatten it and make a drawing. This is my first time using schematics and I am really confused. Previously I have done 3d harness routing but never had to mess with schematics. The new place does not have any library of any sort so I will have to create a library, get 3d models and set it up from scratch.
Is there someone out there who can help me with some ideas to help me get this set up and also answer questions for a first time schematic user?
Your help is very much appreciated.
Thanks
I am new to this forum and this is my first post. I just got a new job in Houston and the job requires me to use Creo Schematics 2.0 and Creo Parametric to route 3d harness, then flatten it and make a drawing. This is my first time using schematics and I am really confused. Previously I have done 3d harness routing but never had to mess with schematics. The new place does not have any library of any sort so I will have to create a library, get 3d models and set it up from scratch.
Is there someone out there who can help me with some ideas to help me get this set up and also answer questions for a first time schematic user?
Your help is very much appreciated.
Thanks