Dear all,
I am designing a Wind turbine rotor with five blades, Now i am simulating the rotor mechanism in Creo Mechanism. My question is, Is it possible to make the rotor to rotate by applying force on the five blades without assigning a Servo motor on the motion axis. (Because this is really happening in the field). And if that possible, will it give the Reaction forces at the blade holding part and other subsequent parts.
(OR) If the above method is not possible, we can go with Servo motor
By assigning a servo motor on the motion axis, we input the rotor velocity and acceleration. Assigning a servo motor along with known force on the Blade will give the Reaction forces.
Expecting you comments.
Thanks,
CADfan
I am designing a Wind turbine rotor with five blades, Now i am simulating the rotor mechanism in Creo Mechanism. My question is, Is it possible to make the rotor to rotate by applying force on the five blades without assigning a Servo motor on the motion axis. (Because this is really happening in the field). And if that possible, will it give the Reaction forces at the blade holding part and other subsequent parts.
(OR) If the above method is not possible, we can go with Servo motor
By assigning a servo motor on the motion axis, we input the rotor velocity and acceleration. Assigning a servo motor along with known force on the Blade will give the Reaction forces.
Expecting you comments.
Thanks,
CADfan