Hi Friends,
I had been using ProE quite a while and just I am back to UG again.
I want to create stepped section in MODELING. In drafting, UG performs well. But the same thing I do want to make it modeling. (I don't want to use assembly cut, it takes too long time to perform operation and quite irritating)
http://www.4shared.com/photo/M9APIVeZ/Section-UG.html
please click the above link for more info.
Thanks frens.
Good luck!
By
Cp
I had been using ProE quite a while and just I am back to UG again.
I want to create stepped section in MODELING. In drafting, UG performs well. But the same thing I do want to make it modeling. (I don't want to use assembly cut, it takes too long time to perform operation and quite irritating)
please click the above link for more info.
Thanks frens.
Good luck!
By
Cp