Hello
Does anyone out there know of any information on 5-axis milling?
I have went through all of the cast and documentaion that is inside of Nx.
It is pretty vauge they give you basically page one and I would like to know pages 2-100.
Right now I am using Nx5 but have access to any version.
Thank you
Robber
Does anyone out there know of any information on 5-axis milling?
I have went through all of the cast and documentaion that is inside of Nx.
It is pretty vauge they give you basically page one and I would like to know pages 2-100.
Right now I am using Nx5 but have access to any version.
Thank you
Robber