In order to make it simple, if i want to make a new part
which fits to an exist part, it'd be better to make it in
assembly by the "new part" under "insert components".
what are you guys doing in order to separate the comopnents
at the end without any question marks on the
"FeatureManager design tree" and minus signs of under
defined?
I'm sorry my lame english. hope i was clear.
thanks, Nir.
which fits to an exist part, it'd be better to make it in
assembly by the "new part" under "insert components".
what are you guys doing in order to separate the comopnents
at the end without any question marks on the
"FeatureManager design tree" and minus signs of under
defined?
I'm sorry my lame english. hope i was clear.
thanks, Nir.