IHAStudent
New member
Hello all,
I have made a simple 3D model and trying to do an analysis of this in SW Simulation.
I have defined material in the part itself and setup the constraints and load situation.
When I click Mesh and run it tells me I have not defined the material. I have tried defining this in the simulation tool itself, but it has the same outcome.
I am using SW 2010/2011 Education Edition.
Any idea on how I fix the problem?
Thanks in advance for your time.
Edited by: IHAStudent
I have made a simple 3D model and trying to do an analysis of this in SW Simulation.
I have defined material in the part itself and setup the constraints and load situation.
When I click Mesh and run it tells me I have not defined the material. I have tried defining this in the simulation tool itself, but it has the same outcome.
I am using SW 2010/2011 Education Edition.
Any idea on how I fix the problem?
Thanks in advance for your time.
Edited by: IHAStudent