Design table Dimensions

[nijs]

hy!


i have a question about the design table option.


is it possible to change dimensions in a assembly drawing of a single part in the design table? if yes, what command should i use?


i tried the help function but couldnt find it.


thanks!
Edited by: nijs

 

[Mihail]

As far as I know, that is not possible. But:
Make a sketch in the assembly. One, two or more lines. Dimenssion this lines, give suggestive names for this dimenssions and put THAT dimensions in the DT. Link the part's dimenssions with this lines (using SKETCH RELATIONS or EQUATIONS).
Now, you can drive the part's dimenssions using DT. Hope you understand "how to".
Good luck !

 

[nijs]

you solved my problem!thanks a lot for the help!