hello everybody
I have a problem about V-thread. I drew this V-thread with Solidworks 2008. I wanna do V-thread with 10 mm pitch. Firstly, I drew a 50 dia; helix with 10 mm pitch and 5 revolutions.
And then, I extrude 50 mm hight with a 50 mm dia; cycle. Finally, I do Sweep Cut with a base lenght 10 mm triangle. SolidWorks can not do this 10 mm triangle. So, I tried Sweep Cut with a 9.96 mm lenght triangle. It is ok.
But I don't wanna this pitch 9.96 mm V-thread. I exactly wanna to do a pitch 10 mm V-thread. What can I do that. Please, everybody help me.
with my best regards,
mr.maung
Edited by: mr.maung
I have a problem about V-thread. I drew this V-thread with Solidworks 2008. I wanna do V-thread with 10 mm pitch. Firstly, I drew a 50 dia; helix with 10 mm pitch and 5 revolutions.
And then, I extrude 50 mm hight with a 50 mm dia; cycle. Finally, I do Sweep Cut with a base lenght 10 mm triangle. SolidWorks can not do this 10 mm triangle. So, I tried Sweep Cut with a 9.96 mm lenght triangle. It is ok.
But I don't wanna this pitch 9.96 mm V-thread. I exactly wanna to do a pitch 10 mm V-thread. What can I do that. Please, everybody help me.
with my best regards,
mr.maung
Edited by: mr.maung