In the "Flat-Pattern", there are bend lines that represent the centerof bend.
IIRC,there is alsoa way to have the bend lines displayed asrepresenting the start and end of bends (as opposed to one linein the center of bend)by changinga setting somewhere.
My problem is that I have forgotten where that toggle is...
There is the chance that I'mmistaken about that toggle showing different bend line representation in the flat and in a part file (not drawing file).For now,all I'mfinding is tangentlines with fontvisiblein a drawing view- which isn't the option for whichI was looking.
I hope that was clear enough, thanks in advance.
IIRC,there is alsoa way to have the bend lines displayed asrepresenting the start and end of bends (as opposed to one linein the center of bend)by changinga setting somewhere.
My problem is that I have forgotten where that toggle is...
There is the chance that I'mmistaken about that toggle showing different bend line representation in the flat and in a part file (not drawing file).For now,all I'mfinding is tangentlines with fontvisiblein a drawing view- which isn't the option for whichI was looking.
I hope that was clear enough, thanks in advance.