Wire cannot be routed to location

[Søren Spætte]

2012-06-21_021059_Cabling.zip


Hej,


I am trying to fix the routing in an existing assembly. But one of the conductors refuses to be routed through a set of locations along the cable, error message:


Cannot route BLACK to a location through which it already passes


It is not shown passing these locations, and cannot be removed as it does not show up on the list of wires when I use Location -> Remove -> ItemFromLocs


Pro/E WF4 M210


Any suggestions?<edited><editID>S

 

[D3syn3rMike]

I suggest deleting the whole cable/segment (delete the "cable/segment" in the model tree orgo to FEATURE >> DELETE >> Del Featwithin cabling)and starting fresh from the entry portrather than trying to fix an existing routing. I run into similar inexplicable warnings andI've come to the conclusion thatI can save my time and sanity by starting over for that particular wire. I have to admit though that my skill level with cabling is low, I'm just learning.

 

[design-engine]

try adjusting your autorout geometry