Horwarth19
New member
I'm having a little trouble here. I have an assembly that has a lot of
welds on it. Some of the welds are inside of other components. See the
below screen shot of what I am looking at when i go to the drawing to create
it. What I would like is when I cut the assembly at the cross section we
only see the edges of the weld, not the whole thing. What parameter am I
not setting up right to get this to happen? Is it something that pro/e just
can't do? Thanks in advance for the help!
View attachment 5369
welds on it. Some of the welds are inside of other components. See the
below screen shot of what I am looking at when i go to the drawing to create
it. What I would like is when I cut the assembly at the cross section we
only see the edges of the weld, not the whole thing. What parameter am I
not setting up right to get this to happen? Is it something that pro/e just
can't do? Thanks in advance for the help!
View attachment 5369