wildfirebrigade
New member
I found its impposible (in WF5) to create a sheetmetal part from a solid cube with intersecting chamfered edges. The only way I can get a flatstate from the part, is to extrude a big hole in the corner prior to converting to sheetmetal. See image:
Any suggestions for a proper solution??
View attachment 4650
<div menubottom="0" menuright="0" menutop="0" menuleft="0" activeid="-1" expanded="0" style="display: none;" id="divCleekiAttrib"></div><div menubottom="0" menuright="0" menutop="0" menuleft="0" activeid="-1" expanded="0" style="display: none;" id="divCleekiAttrib"></div>
Edited by: wildfirebrigade
Any suggestions for a proper solution??
View attachment 4650
<div menubottom="0" menuright="0" menutop="0" menuleft="0" activeid="-1" expanded="0" style="display: none;" id="divCleekiAttrib"></div><div menubottom="0" menuright="0" menutop="0" menuleft="0" activeid="-1" expanded="0" style="display: none;" id="divCleekiAttrib"></div>
Edited by: wildfirebrigade