bryanbryan010
New member
I'm not sure where to post this but i've encountered several problems when regenerating my complex assembly.
When i regenerate my main asselmbly, which consists of many sub assemblies, i get kicked out. After hours of tracing, i discovered that the problems lies with 1 part (the main housing).
I tried to supress features and stuff but when i regenerate, i get kicked out of proE wildfire 2.
Are there any ways i can overcome this? Should i not regenerate my model from now on?
When i regenerate my main asselmbly, which consists of many sub assemblies, i get kicked out. After hours of tracing, i discovered that the problems lies with 1 part (the main housing).
I tried to supress features and stuff but when i regenerate, i get kicked out of proE wildfire 2.
Are there any ways i can overcome this? Should i not regenerate my model from now on?