PDA

View Full Version : insert mode in UG



design-engine
07-01-2013, 08:49 PM
Is there something I'm missing with the interface to allow insert mode like in Pro/E or Solidworks? In Pro/E I want to drag the red arrow up so when I add a feature it stays where I insert it. The work around which Is what I teach would be to add the feature at the end and reorder the feature to the appropriate location.

design-engine
07-29-2013, 09:48 PM
I found it... 'make current feature' you can go into insert mode like in Creo or SW but you don't have the line or arrow. You right hold down over the feature in the model tree that you want to insert after and select 'make current feature'