Hi,
I am having some problems, here is what I would like to do.
Part 1 = A 3 sided pan in sheet metal (done ) Part 2 is the left end cap and my problem is I would like to trace on the end along the pan's edge but I can't select the edge. I can do these separate, and then insert them into the assembly but its tricky to get the end cap just right so by tracing the pan its more to size.
Any help on this would be great!
Edited by: RMS1
I am having some problems, here is what I would like to do.
Part 1 = A 3 sided pan in sheet metal (done ) Part 2 is the left end cap and my problem is I would like to trace on the end along the pan's edge but I can't select the edge. I can do these separate, and then insert them into the assembly but its tricky to get the end cap just right so by tracing the pan its more to size.
Any help on this would be great!
Edited by: RMS1