I have a tapered shaft, collet and collet ring. I have to create two exploded views:
First Exploded View: The bigger diameter of shaft with the collet (no collet ring)
Second Exploded View: The smaller diameter of shaft with the collet and collet ring.
The problem arises when I rotate the shaft 180 degrees and try to create the second view. Both the views should be in the same drawing sheet.
Anysuggestion in this regard will be helpful.
Thanks,
Rajesh S
First Exploded View: The bigger diameter of shaft with the collet (no collet ring)
Second Exploded View: The smaller diameter of shaft with the collet and collet ring.
The problem arises when I rotate the shaft 180 degrees and try to create the second view. Both the views should be in the same drawing sheet.
Anysuggestion in this regard will be helpful.
Thanks,
Rajesh S