Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

temporary rotation point in NX5

nicoolai

New member
I wasn't really sure where to put this topic, so here goes.
In NX5, you can rotate your view by holding down the middle mousebutton. If you hold it down for about a second, without moving, you set the current cursor location as a rotation point, overriding any rotation points you have already set.
Is there a way to disably this, or maybe configure it? Maybe change the delay it requires to set the temp rotation point?
 

Sponsor

Articles From 3DCAD World

Back
Top