dmiller327
New member
I am new to UG. In fact our company is making the switch from ProE to UG so there are not much internal resources available. Our standard thread callouts under ProEhave included tap drill diameter and depth, thread nominal diameterand depth. In NX5 drawing module, using Feature parameter icon and selecting the two features representing the tapped hole I end up with two call outs each with aseparate leader. One for the hole and one for the thread.
Is it possible to combine these callouts into a single one? i have done some searching on ht enet and experimented in NX but I could use a little help in understanding how the call outs work. Where they get their info and what I need to modify to get what I want.
Thanks.
Is it possible to combine these callouts into a single one? i have done some searching on ht enet and experimented in NX but I could use a little help in understanding how the call outs work. Where they get their info and what I need to modify to get what I want.
Thanks.