Hello,
I am a Unigraphics NX4 user and I have this error that happens a lot on passing by the mouse cursor on a model... no complicated operation.
The error message is the following :
Error recovery completed for the following error:
Modeler error: failed to find closest approach
This problem was also occuring in the previous NX3 version.
Please help me if you know that problem.
Edited by: Guigui92
I am a Unigraphics NX4 user and I have this error that happens a lot on passing by the mouse cursor on a model... no complicated operation.
The error message is the following :
Error recovery completed for the following error:
Modeler error: failed to find closest approach
This problem was also occuring in the previous NX3 version.
Please help me if you know that problem.
Edited by: Guigui92