Anyone got a good way of adding a company logo to a model? Basically we produce equipment that is either engraved / etched or uses printed stickers as decals.
I used to use Pro/E and could use a jpg of the logo onto a surface - this was fairly good but had a few problems. Anything similar for NX3?
Using text sketched and then extruded to a shallow depth (as basically is done in real life) slows the machine down to crawl after a few words are added. It also requires a complex sketch for our logo:
Regards.
I used to use Pro/E and could use a jpg of the logo onto a surface - this was fairly good but had a few problems. Anything similar for NX3?
Using text sketched and then extruded to a shallow depth (as basically is done in real life) slows the machine down to crawl after a few words are added. It also requires a complex sketch for our logo:
Regards.