Bend the Solid in NX3 .( From Viet Nam )

HI everybody !


I'm using NX3 . Can u tell me how to bend the Solid follow the curve ? (In Pro Eng , a similar command that Bend ). That Solid have aspecialy geometry on it .( A rid , ect ... ) and the curve could be a conic ( elipse ..) .


I tried to use the Sketch . But not axactly ! and lost much time . And we can't use Instance / Array .( because the solid not cylinder , itbelong to a conic )

HiPham,


I'm not sure about bending the solid following a curve, but I would suggest you to draw a curve first then draw a geometry from one end of the curve and sweep along a guide.


I hope I did give you the answer.


peace out