CC>>Inferno
New member
I posted this in the modeling section but figured people here might have answers to this too. Please check it out and see if you can help me.
I am using a design table to drive dimensions of planes in my assembly,
and then using mate references, I drag parts in so everything will mate
correctly in the right spot with out having to do anything else. The
question is; Is there a way to get the design table to reference a data
base of part numbers and insert selected parts into the assy? And if
that works, how do i get those parts to follow the mate references when
they come in?
Edited by: CC>>Inferno
I am using a design table to drive dimensions of planes in my assembly,
and then using mate references, I drag parts in so everything will mate
correctly in the right spot with out having to do anything else. The
question is; Is there a way to get the design table to reference a data
base of part numbers and insert selected parts into the assy? And if
that works, how do i get those parts to follow the mate references when
they come in?
Edited by: CC>>Inferno