Continue to Site

Welcome to MCAD Central

Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.

Pro/E datum curves

inesm

New member
hello,



how can i divide a datum curve in parts with different lengths (an establish a relation between them...)?



thanks.
 
Try this



Sketch first a curve in part mode, then sketch points on (Points>on curve> and select Actual Len or Length Radio).

Then redraw again the same curve with the UseEdge option in Sketcher using the points as reference to trim the curve. You have to sketch one curve every time to connect each point together.

As the result you have now curves (depents of the number of the points) that has the Actual Len or the Length Radio option inside, so if you change the values of these options the curnes follows them

Then you can use this values to establish a relation between them.



I hope this works



Regards

xcad
 
Hello



I think the above solution can work with other curves.

Lets try the same to one curve created with the two projections method.

First sketch one curve individually and then the second curve also, to another plane.

Create a two projections curve taking reference the two curves you have just created.

Now you have three curves. On the projected curve create a plane (you will use this plane later as sketching plane). Use Insert Datum Plane>Through> pick the projected curve > Done.

Create points again with the method LenghtRadio or Actual Len with the Insert Points > On curve, on the projected curve.

Now begin creating curve selecting the plane you have created above (through the curve) and select two points to take as reference for sketch (the points you created above). With the Use Edge command select the projected curve and trim the curve outside of the two points (if you have problem with that, sketch centerlines through the points. As the result you have a curve that connects the two points and similar to the projected curve.

Now pick the two curves you created first (those you use to make the projected) and change any dimension you want, change the value of the Length Radio or Actual Len (the option you use), of the points that drive the curve, and regenarate.

You can see that the curve stll connects the two points and it is similar to the projected curve.

As a result is that we have different curves between the points we want to have dimensions and the curves are taking reference these points and are similar to the projected curve.



Regards

xcad
 

Sponsor

Articles From 3DCAD World

Back
Top