Hello,
I want to make a hole with a thread in.
I want to have an M20 so i change it into ISO
But when it's M20 the diameter of the hole changes to a small one.
The diameter is 0,7 then
I heard my creo stands in the unit : inch
How can i change this to mm?
Thanks in advance
I want to make a hole with a thread in.
I want to have an M20 so i change it into ISO
But when it's M20 the diameter of the hole changes to a small one.
The diameter is 0,7 then
I heard my creo stands in the unit : inch
How can i change this to mm?
Thanks in advance
Last edited: