I am having a hard time opening the three files which are generated when I create a new FEM and Simulation in NX4 which are stored it in TcE.
When I work in native mode it is just a matter of opening the files in question (.fem/_i.prt/.sim) but I am not able to do this when I store the files in TcE - I cannot "double-click" on the files and open them. Only my original .prt-file is can be opened this way. Starting the Advanced Simulation module only allows me to create a new FEM and Simulation set of files.
I guess this is a tricky question to answer but I am curious to see if anyone else are having similar problems. Any ideas?
//Joru
When I work in native mode it is just a matter of opening the files in question (.fem/_i.prt/.sim) but I am not able to do this when I store the files in TcE - I cannot "double-click" on the files and open them. Only my original .prt-file is can be opened this way. Starting the Advanced Simulation module only allows me to create a new FEM and Simulation set of files.
I guess this is a tricky question to answer but I am curious to see if anyone else are having similar problems. Any ideas?
//Joru