Dear all,
In one of the mechanism assembly, the Mechanism
runs smoothly for one time and after sometimes if i re-
run the analysis again the Rigid body(i.e the fixed part
in the mechanism) spins instead of the Rotating member
and also simulataneusly the whole mechanism zoom in and
zoom out until it reaches the 100% of the analysis. I
don't know why this happen.
Can anyone give some clue how to correct this problem.
Thanks
CADfan
In one of the mechanism assembly, the Mechanism
runs smoothly for one time and after sometimes if i re-
run the analysis again the Rigid body(i.e the fixed part
in the mechanism) spins instead of the Rotating member
and also simulataneusly the whole mechanism zoom in and
zoom out until it reaches the 100% of the analysis. I
don't know why this happen.
Can anyone give some clue how to correct this problem.
Thanks
CADfan