Hi All,
I want to check interference between two plastic parts in
an assembly using "pairs clearance"
When I open the dialogue box i notice that there are no
drop down panels in the FROM of TO boxes. I thought given
some thing I had read that I should be able to choose
between PART, SURFACE, CABLE and so on?
In any case (using smart select) I was able to choose one
part and a surface of the other with which I know there
is interference. Pairs clearance however reports Zero
clearance. I the tried to select the same part and the
other part rather than just its surface. Again proe
reported zero clearance but did report a volume
interference and highlighted the correct area of
interference.
Can anybody explain whats going on here? I would have
expected proe to report a negative clearance or does it
not wotk this way?
Any help appreciated.
regards
Padraig.
I want to check interference between two plastic parts in
an assembly using "pairs clearance"
When I open the dialogue box i notice that there are no
drop down panels in the FROM of TO boxes. I thought given
some thing I had read that I should be able to choose
between PART, SURFACE, CABLE and so on?
In any case (using smart select) I was able to choose one
part and a surface of the other with which I know there
is interference. Pairs clearance however reports Zero
clearance. I the tried to select the same part and the
other part rather than just its surface. Again proe
reported zero clearance but did report a volume
interference and highlighted the correct area of
interference.
Can anybody explain whats going on here? I would have
expected proe to report a negative clearance or does it
not wotk this way?
Any help appreciated.
regards
Padraig.