Jonas_1977
New member
Hi,
I am having problems with hatching of an x-section, see picture below. The hatching does not follow thecontour. If I look at properties of the hatching (MOD XHATCH)green lines appear, and this is the contour that the hatch follows, see pic 2. I thought it was a graphic problem, but when I print the drawing I get the same result.
//jonas
View attachment 3317
View attachment 3318
I am having problems with hatching of an x-section, see picture below. The hatching does not follow thecontour. If I look at properties of the hatching (MOD XHATCH)green lines appear, and this is the contour that the hatch follows, see pic 2. I thought it was a graphic problem, but when I print the drawing I get the same result.
//jonas
View attachment 3317
View attachment 3318