lining up hole with existing point

[fjbart2069]

I created a sketch with points to use as positons for holes. I select Hole Wizard and then position to cerate hole. HW will not let me "select" existing points so I put a hole close to me reference point. Now I go into the 3D sketch for the hole and try to move the hole and "spap" it to the existing reference point, but it will not snap.


How can i move the hole created in HW to existing refernce point?

 

[tomwalls]

Within the sketch that contains the center points for the holes, you should be able to control click the hole center point, then the datum point, then click "coincident".

 

[nucu]

I don't understand why you make a sketch with points when
holes from wizard, for positioning, uses points?