Hello everyone,
I am running wf3 on a Haas vf3ss. I want to create a helical trajectory to hog out a hole. The problem is if I use machine -circ_interpolation - arcs only the Haas runs the tool in a circle without moving down in z, if I use points only the tool path circles are not all concentric and gouges the part! I would also like to add profile stock allow and axis shift if possible
thanks for any help rrr
Edited by: rrrhaas
I am running wf3 on a Haas vf3ss. I want to create a helical trajectory to hog out a hole. The problem is if I use machine -circ_interpolation - arcs only the Haas runs the tool in a circle without moving down in z, if I use points only the tool path circles are not all concentric and gouges the part! I would also like to add profile stock allow and axis shift if possible
thanks for any help rrr
Edited by: rrrhaas