Hi everyone, I am working with gears on pro/e, something I havent done before properly.
I have a gear from one of our suppliers (not sure who!) it has a number printed on it...
111-030-625
The gear has 25 teeth (end part of the number)
The outside dimension is around 80mm
is the number on the gear a standard format? I have tried downloading the gears on here from "files" but when I enter in my info they fail regeneration.
Just after a bit of advice and guidance on this.
Thanks
I have a gear from one of our suppliers (not sure who!) it has a number printed on it...
111-030-625
The gear has 25 teeth (end part of the number)
The outside dimension is around 80mm
is the number on the gear a standard format? I have tried downloading the gears on here from "files" but when I enter in my info they fail regeneration.
Just after a bit of advice and guidance on this.
Thanks