G81

[proone]

Hello :

Does anyone know how to make post complete all the holes in the cycle?. I have two holes here but I see only one hole is posted. I see both in the screen display of toolpath but only one after is posted

Thanks in advanced

James

%
N1 (Date:06/29/12 Time:21:19:30)
N2 G90 G94 G54
N3 G40 G49 G90.1
N4 S2000 M3
N5 G0 X-25. Y16.
N6 Z6.5
N7 Z3.5
N8 Z6.5
N9 X-19.97 Y7.24
N10 G81 X-16.09 Y8.76 Z-1. R6.5 F55
N11 G80
N12 M6
%

 

[dbrainsky]

Will need to see the ncl file to determine if the holeset is correct. PTC will show a message if the holes could not be drilled. Did you notice any messages?