G-Post Compability

[bimbo666]

Hi dear friends,


The company that I'm working on, is now making the updgrade from wildfire 2.0 to wildfire 3.0, some of my CNC programmers told me, that they had been having problems with all the old post-processors made in wildfire 2.0, when they were trying to copy to the new wildfire 3.0 already installed.


Is any difference between these two g-post realeses?. How can these guys do to work with their old post-preocessors . Myabe the answer of this question is so simple to anyone of you, I apologized I'm not a CNC programmer, I'm a mechanical Engineer.


Thanks your all your advice





Best Regards


Pablo Ulloa

 

[appinmi]

Our company went from WF1 to WF3. There was no problem using the old posts. There were some new settings with the new posts that would allow you to make some minor changes, but the posts worked just fine.