Floating Module CASTING greyed out

[johnszar]

When I launch Pro/E WF2 I can acquire the floating module for CASTING and use this module. Loaded Pro/E WF 4 will same license bundles, But CASTING is greyed out in the floating modules dialogue and when I select File>New>Manufacturing Cast Cavity and Mold Cavity are both greyed out. Was there and option I missed during the installation of Pro/E WF 4? PTCstatus shows an open CASTING license, license file shows that it is a WF 4 CASTING license. I am still able to check out the license with WF 2 and none of these options are greyed out. Any Ideas?

Thanks,

 

[johnszar]

Found out, that even though my license listed as 4.0 it was listed as
WF 4.0 PreProd Flt Opt perm

Which means it is only for WF 4 pre production version of the software and need to get the license updated to run with production version of the software.