ProE Wildfire 5 M020
Rectangle extrusion to triangle protrusion is not
conforming to surface. Rounded triangle protrusion base
edge seems to be the problem and the extrude goes through
the protrusion and seems to go under as if it cannot
detect where to stop at the rounded section and the co-
aligned and constrained top plain (just a guess though it
may be something else).
View attachment 5594View attachment 5595View attachment 5596
View attachment 5597View attachment 5598
View attachment 5599
Part File
2012-04-11_205351_100_oxi_out_seal.prt.zip
Edited by: Skie
Rectangle extrusion to triangle protrusion is not
conforming to surface. Rounded triangle protrusion base
edge seems to be the problem and the extrude goes through
the protrusion and seems to go under as if it cannot
detect where to stop at the rounded section and the co-
aligned and constrained top plain (just a guess though it
may be something else).
View attachment 5594View attachment 5595View attachment 5596
View attachment 5597View attachment 5598
View attachment 5599
Part File
2012-04-11_205351_100_oxi_out_seal.prt.zip
Edited by: Skie