Drawing of flat pattern

[kmargaris]

I want to create a drawing of a sheet metal part in the flat pattern state, but
I need to keep the model in the corresponding part file in the formed state.
Is it possible to do it in pro/e?

 

[prohammy]

In your model.....


Edit>- Setup>- Flat State>- Fully Formed> pick a driving surface and an instance of the sheet metal part in a flattened state is created (called xxxxx_flat).....


In your drawing....


Add a new model (the instance of that sheet metal part), set the model to that _flat and add new viewto your drawing


Kev

 

[arroyopr]

Your could create a family table for the model state and thenon your drawing RMBgo properties,add model, ......