Drawing Compatibility - M030 & M020

[Ricc Smitt]

Hello Everyone


ArethereCompatibility issues between Wildfire 3 M020 and M040 or other releases?


If a drawing was done in WF 3 M040, can I open it an older release of WF like M030 or any other older version?


Thank you


Ricc


(BTW: - I'm not the Drafter, just a hardware tech)

 

[dr_gallup]

USUALLY, thee is no problem opening files with different build codes of the same release. There have been exceptions but I'm not aware of any with the WF3 builds so far. You can NEVER open files with an older release. WF2 will not open files saved in WF3.