Join our MCAD Central community forums, the largest resource for MCAD (Mechanical Computer-Aided Design) professionals, including files, forums, jobs, articles, calendar, and more.
Hi colleagues. I have a question. When drawing the shaft
with designated tolerances of diameter sizes(dimensional
tolerance) is there a way to be considered when making the
NC program? If anyone can help? Thanks
I'm assuming you are using a class of fit system like h6 etc with asymmetric tolerances. You can go into edit/setup/dim bound and set the diameter to middle. This will cause the geometry to regenerate to the center of the tolerance even though the dimension will still say the nominal value.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
