Hi,
At aproject review, I have to make "tolerance worst case anaysis".
My intention was to create the sections, thrue the assembly,on drawing and then in the table to calculate the worst case gap/interference, associativelly.
The table will contain the "nominal gap" take it from section dimension (&addxxx), the position tolerance, and the "worst case".
The problem is how to calculate the "worst case" value from table, associative?
I try to create a parameter from the dimension value, but doesn't work...
Thanks
At aproject review, I have to make "tolerance worst case anaysis".
My intention was to create the sections, thrue the assembly,on drawing and then in the table to calculate the worst case gap/interference, associativelly.
The table will contain the "nominal gap" take it from section dimension (&addxxx), the position tolerance, and the "worst case".
The problem is how to calculate the "worst case" value from table, associative?
I try to create a parameter from the dimension value, but doesn't work...
Thanks