decimal digit in measurements

[luca.taddeucci]

when I try to measure something in an assembly, sometimes WF2 gives back a result without decimal digit, so to have the exact value I always have to create the drawing even if I don't need it.


This problem didn't happen in 2001. Is there any parameter that I have to set in a different way.


Thank you

 

[airion]

Try changing this config setting: measure_sig_figures

 

[luca.taddeucci]

thank you AIRION,


your suggestion solved my problem: my setting was 3, so I always had 3 digit answers.


bye and thank's again





luca